T0696, HEATED GRIPS, OXFORD
OXFORD HEATED GRIPS
T0696, HEATED GRIPS, OXFORD Order Here
Over the years TPI has searched and
tested several heated grips with none to our liking. Either too
difficult to install or just cheaply made. Finally we have found a grip
that meets our demands and we hope you are pleased with them too.
Oxford heated grips Fit 7/8’’diameter handlebars with 4.75″ to
4.9″-long. Maximum power consumption of 48 watts per pair (4.0 amps at
12-volt DC). Grips heat up to 122 degrees Fahrenheit (50 degrees
Celsius). Grips are 125mm (4.9″) long. Includes waterproof electronic
controller with following features:
4 power settings (100%, 75%, 40%, 30%);
LED indicates current power setting;
On/Off switch with LED indicator light;
Double-stick tape included for flush mount of controller on fairing;
Includes bracket for mounting controller on
left-side handlebar control mount bolts (pre-drilled for two M6 mounting
screws spaced 31mm-35mm apart on center)
Controller size: 56mm wide x 54mm tall x 20mm thick
Includes fused, pre-terminated wiring harness with
two 1.4″/M6 ring terminals for connection to your motorcycle’s battery.
No wiring tools are required for installation – simply plug the grips
and controller into the included wiring harness, attach two wires to
your battery terminals, and the wiring is finished!
Includes a tube of high-temperature epoxy for installing grips.
Grips have bored-out ends and are designed for easy
installation on bikes with bar-end weights or brush guards.
If your bike does not currently have bar ends or
guards you can still install these grips, but your bar ends will remain
Simply put, this is the most complete, easy to install
heated grip kit currently on the market, and it’s available at a great
Fit all years KLR, Dr 650, DL 650 & 1000. They
also fit the Super Sherpa, DRZ and many makes of BMW, and most Japanese
bikes with 7/8’’ bars.